Cases26 cases

11 to 15 of 26

1. IL-0161 A faulty earlier API update made new LKE cluster provisioning in Toronto time out for three days, leaving clusters with no node pools or the wrong number of nodes

   Linode2024

   Symptoms

   At about 14:05 UTC on 22 April 2024, Linode's team noticed that new LKE clusters were failing to provision in the Toronto data center.

   Cluster or node provisioning stallIntermittent timeouts

   Trigger

   A previous update to the API did not work as intended and caused timeouts when new LKE clusters were provisioned.

   Root cause

   Software defect

   Component

   Node pool

   Contributing factor

   –

   Detection

   Linode's team noticed new LKE clusters failing to provision in the Toronto data center at about 14:05 UTC on 22 April 2024.

   Remediation

   • disabled the affected section of Toronto infrastructure from provisioning new LKE clusters
   • implemented a fix for the faulty API update
   • put the disabled infrastructure back into use after the fix

   Lessons

   The fault was in an earlier API change, not in the infrastructure that showed it, but most failures concentrated on one backend resource in one data center. Taking that resource out of provisioning limited the impact while the root cause was found, which took three days.

   View case
2. IL-0169 The Scaleway Kubernetes API in FR-PAR ran out of memory under simultaneous deployments, and because it also handled node authentication, Kapsule and Kosmos nodes went NotReady

   Scaleway2024

   Symptoms

   At 23:48 CET on 24 January 2024 the Scaleway Kubernetes API for the FR-PAR region ran out of memory. At the same minute Scaleway saw requests to its API Gateway spike.

   Node NotReadyOOMKilledIntermittent timeoutsMonitoring outage

   Trigger

   Simultaneous deployments in the FR-PAR region pushed the Scaleway Kubernetes API out of memory.

   Root cause

   Capacity exhaustion

   Component

   Container memory limitkubelet

   Contributing factor

   Single point of failureRetry storm

   Detection

   Increased load on the API Gateway was detected at 23:48, the minute the incident began, and the incident was escalated to on-call engineers at 00:00:10.

   Remediation

   • raised the memory limit and garbage collection thresholds of the Kubernetes managed services
   • deployed additional replicas of key services
   • purged the registry cache and monitored the clusters as they stabilised
   • adjusted service configurations after the incident to keep the platform stable

   Action items

   • Implement a local authentication cache
   • Further develop node authentication
   • Enhance monitoring, adjust rate limiting strategies and improve incident response protocols

   Lessons

   Because the Kubernetes API also handled node authentication, its memory exhaustion made some nodes NotReady, and the endless retries of those nodes added load on the API Gateway. Scaleway plans a local authentication cache and further work on node authentication.

   View case
3. IL-0386 After a move to Google Cloud, Postgres connection timeouts and memcached i/o timeouts spiked on GKE nodes

   incident.io2023

   Symptoms

   Shortly after incident.io moved its infrastructure fully into Google Cloud, the application saw a larger-than-normal number of Postgres connection timeouts, and new database connections per second were in the hundreds, spiking up and down. At the same time, the memcached instance used for transient data and faster API responses had sporadic connection timeouts.

   Intermittent timeoutsPacket loss

   Trigger

   After the move to Google Cloud, the application opened hundreds of new Postgres connections per second, and an accidental database join made it send thousands of duplicate calls to an external third party in parallel.

   Root cause

   Capacity exhaustion

   Component

   CNI pluginDatabaseIn-memory cache

   Contributing factor

   Unreviewed defaultsOverlapping failures

   Detection

   An incident was declared when the number of Postgres connection timeouts rose above normal. The remaining cache timeouts were traced through the logs of the Kubernetes node that served an affected request, the request's trace and the node's metrics.

   Remediation

   • Doubled the maximum Postgres connection lifespan from 15m to 30m
   • Made the Postgres connection pools static so they always keep N connections open
   • Raised the memcache client's MaxIdleConns from 2 to 20
   • Moved temporarily from Google's hosted memcached to a memcached inside the Kubernetes cluster
   • Shipped the fix for the accidental database join that made thousands of duplicate external calls

   Action items

   • Set more sensible concurrency limits for outbound network calls

   Lessons

   Network timeouts are not always local to one request or pod: when they appear, the whole activity of the node, including other pods on it, needs to be checked. Staying within a provider's rate limits does not keep outbound calls from affecting a node, so outbound network calls need more sensible concurrency limits.

   View case
4. IL-0112 The daily node rollover put DFDS's EKS nodes on an AMI later recalled for a kernel issue, causing "PLEG is not healthy" NodeNotReady flaps and pod network timeouts

   DFDS2022

   Symptoms

   On 2022-10-31 a planned upgrade of the vpc-cni EKS add-on, started from the deployment pipeline at 13:45 UTC, timed out at 14:10. Only about 10 of the 45 aws-node pods had upgraded, 5 were stuck in Terminating and the other 30 had not been attempted.

   Node NotReadyUpgrade stallIntermittent timeoutsIntermittent connection failures

   Trigger

   At 07:30 UTC on 2022-10-31 the daily node rollover replaced the existing nodes with nodes built from AMI v20221027, the latest AWS EKS node AMI, released on 2022-10-29 and later recalled because of a kernel issue.

   Root cause

   Software defect

   Component

   Node operating system imageLinux kernelkubeletAWS VPC CNINode launch templateTerraform

   Contributing factor

   No staged rolloutAutomation amplificationOverlapping failuresMonitoring blind spotNo health probes

   Detection

   The team noticed nodes flapping between NodeNotReady and NodeReady ("KubeletNotReady PLEG is not healthy") at 14:30 UTC while watching the stalled vpc-cni upgrade, about seven hours after the rollover. Time to detection was 7 hours. Alerting did not catch the NodeNotReady events or the socket growth.

   Remediation

   • cordoned, drained and deleted 15 stuck nodes one at a time to complete the vpc-cni upgrade
   • changed the Terraform infrastructure-modules so a specific AMI could be set
   • rolled the EC2 Auto Scaling group launch configuration back to the previous known good AMI through the pipeline

   Action items

   • Reach out to teams with suggestions about readiness and liveness probes
   • Create a dashboard for readiness and liveness probe coverage
   • Write a wiki article on readiness and liveness probes and their usefulness
   • Modify infrastructure-modules to allow specifying a particular AMI
   • Schedule a discussion on whether to take the latest AMI immediately and how to test new AMIs before they are deployed
   • Implement alerting on abnormal NodeNotReady events and on increased socket use
   • Create a learning path for Kubernetes within the team
   • Collect logs from nodes centrally
   • Create a Prometheus exporter that retrieves the latest available AMI, with a dashboard and alerts

   Lessons

   When a new node AMI has just been rolled out, upgrading other cluster components on the same day makes it hard to tell which change is causing trouble; here the vpc-cni upgrade on the same day confused matters. Taking the latest AMI automatically with no way to pin one meant a rollback first needed a Terraform change. The team also concluded that it needs better communication paths with application teams during incidents.

   View case
5. IL-0178 On EKS, HPA scale-in returned 502 errors because containers stopped before their pod IPs left the Service endpoints, and after blue/green switches conntrack kept sending established connections to deleted pods behind an instance-mode ALB

   Lotte E-commerce2022

   Symptoms

   LOTTE ON, Lotte E-commerce's online shopping mall of about 40 microservices on Amazon EKS, returned errors for a period of time whenever the Horizontal Pod Autoscaler (HPA) scaled pods in after load dropped. Requests reached containers that had already been deleted and failed with 502 errors.

   High error rateIntermittent timeoutsStale endpoint routing

   Trigger

   HPA scale-in deleting pods, and the deletion of Blue pods after a blue/green switch of the Service label selector.

   Root cause

   DNS or network fault

   Component

   Horizontal pod autoscalerPod terminationkube-proxyconntrack tableCloud load balancerIngress controller

   Contributing factor

   Unreviewed defaults

   Remediation

   • delayed container shutdown on pod deletion (a wait in the SIGTERM handler or a preStop sleep, capped by terminationGracePeriodSeconds) so containers stop only after the pod has left the Service endpoints
   • switched some workloads' Ingress-created ALBs from instance mode to IP mode so traffic goes straight to pod IPs without iptables and conntrack

   Action items

   • Move all workloads to ALB IP mode gradually

   Lessons

   Removing a pod from Service endpoints and stopping its containers happen at the same time in Kubernetes, so a pod can stop while traffic is still routed to it unless shutdown is delayed with a preStop hook or in the application. With an instance-mode ALB, traffic passes through node iptables and conntrack, and established connections can keep going to a pod IP after its iptables rules are gone. IP mode avoids that path, within the limit of 1000 targets per target group.

   View case

By root cause7