Cases4 cases

1 to 4 of 4

1. IL-0100 PostHog's feature flags pods were packed onto Kubernetes nodes that were too small for their CPU requests, and CPU saturation above 90% caused three outages in ten days through Redis overload, connection pool exhaustion and slow queries

   PostHog2025

   Symptoms

   On 21 October 2025 at 21:45 UTC a change to timeout handling was deployed to the feature flags service, and two minutes later automated monitoring reported higher error rates. The change was rolled back by 21:49, but error rates stayed high: about 38% of flag evaluation requests in the US datacenter returned errors. At 22:30 Redis metrics showed memory exhaustion on ElastiCache, at 22:35 Postgres connections spiked, and at 22:45 the team found a massive data transfer from Postgres into Redis. The main PostHog application was affected as well, because it shares the Redis instance with the flags service.

   Sustained high node CPUHigh error rateHigh latencyContainer crash loopDatabase overload

   Trigger

   On 21 October a deployment meant to reduce timeout errors (PR #39821); on 24 October the deployment of IP-based rate limiting (PR #40074) that saw all traffic as coming from the load balancer's IP; on 28 October an unrelated routine deployment that rolled the feature flag pods in the US region.

   Root cause

   Capacity exhaustion

   Component

   Node poolPod scheduling and placementIn-memory cacheApplication database

   Contributing factor

   No alert on limitRetry stormIneffective rollbackSingle point of failureNo staged rolloutUnrepresentative staging

   Detection

   On 21 October automated monitoring detected higher error rates two minutes after the deploy. On 24 October no alert existed for 429 errors, and the team learned of the incident from customer reports that began at 18:10 UTC, a 62-minute detection delay. On 28 October on-call received a high error count alert. On 29 October the incident was reported with higher error rates and latency. No alert existed for CPU pressure, so the CPU saturation behind all three incidents was not seen directly.

   Remediation

   • rolled back the timeout handling change within 2 minutes on 21 October, which did not stop the errors
   • throttled connections and Redis writes on 21 October
   • halted the rollout on 28 October, scaled the US flags pods to zero until Redis recovered, then scaled them back gradually
   • rolled back hardware changes on 30 October at 00:03 UTC, which removed most errors but not the latency
   • increased the pod resource requests and adjusted the Kubernetes fleet size so fewer pods ran on each node
   • added retry limits to Envoy between the load balancer and the service
   • moved database connection timeouts and other critical settings to runtime configuration and raised the timeout values
   • added per-node and per-pod CPU alerts at 80% sustained for 5 minutes that page on-call

   Action items

   • Form a strike team from the flags, ingestion and infrastructure teams to review the application and infrastructure for remaining bottlenecks
   • Investigate separating the flags Redis instance from the application Redis instance
   • Before re-enabling ArgoCD sync, align the flags service chart configuration with the values in ArgoCD and define the deployment and Redis strategy
   • Make the feature flags team hard code-owners for flags-related code
   • Build a dashboard of key flag metrics with runbook links and update the feature flag runbooks
   • Add missing alerts on existing service and infrastructure metrics
   • Make readiness checks validate dependencies that degrade under load, for example by pinging the database
   • Rate-limit cache population so it cannot overwhelm Redis
   • Monitor connection pools with automatic throttling near exhaustion and limit concurrent connections
   • Build a production-scale load testing framework
   • Build progressive rollout infrastructure to limit blast radius
   • Document Postgres-to-Redis data flows and write runbooks for data transfer storms

   Lessons

   Nodes that are small relative to pod requests let the scheduler pack many pods on each node, and the resulting CPU saturation showed up three different ways: excessive parallelism, connection pool exhaustion and slow queries. Treating each symptom separately let the problem return; right-sizing the pods and nodes fixed all three. CPU must be alerted on from the start. Unbounded Envoy retries and unbounded cache population amplified the overload, and a Redis instance shared with the main application spread a flags problem to the main application. A rollback did not end the incident, because the data transfer and resource exhaustion it had started kept running.

   View case
2. IL-0202 A burst of queries and database writes exhausted connection pools and memory on Honeycomb's ingest hosts, and Kubernetes crash-loop back-off kept failed hosts offline so ingest capacity stayed too low to recover

   Honeycomb2023sev1

   Symptoms

   Standard alerting paged Honeycomb's on-call engineers about the performance and stability of event ingestion, and the automated load-shedding mechanisms tripped and sent further notifications. The status page described a higher than normal error rate and response time on the ingestion service.

   High error rateHigh latencyContainer crash loopService outageDatabase overload

   Trigger

   An abnormally large number of queries arrived from many separate connections within a few minutes.

   Root cause

   Capacity exhaustion

   Component

   Application databaseIn-memory cache

   Contributing factor

   Retry stormAutomation amplification

   Detection

   Standard alerting notified the on-call engineers about ingestion performance and stability, and the automated load-shedding mechanisms added notifications when they tripped. The first status post, about alerts on a higher than normal error rate and response time, went up at 18:28 PST (02:28 UTC), 13 minutes after the 02:15 UTC start.

   Remediation

   • Scaled the ingest fleet up manually and aggressively
   • Cut off most ingest for a few minutes so the ingest hosts could come back with enough capacity
   • Temporarily lowered the rate limits for the most aggressive traffic sources until their traffic subsided

   Action items

   • Keep the ingest fleet scaled up to prevent a repeat while longer-term fixes are worked on
   • Decide on the projects that will address these failure paths

   Lessons

   Load shedding and auto-scaling were in place, yet a burst that arrived faster than the cache could spread its writes still took the ingest hosts down. During recovery, Kubernetes' crash loop back-off worked against the operators: the hosts that had failed stayed offline while the fleet needed every host. Clients that retry whole OTel batches after a partial drop can multiply traffic many times over, so per-source rate limits were what finally stabilised ingest.

   View case
3. IL-0206 Consul agents in GitLab.com's GKE pods were repeatedly OOM-killed, so the Rails pods lost database replica discovery and sent every query to the primary

   GitLab2022

   Symptoms

   On 2022-04-25 the Sidekiq Apdex (the share of background jobs that finish within a target time) dropped, and an engineer declared an incident in Slack at 15:13 UTC. Users saw intermittent slowness across GitLab.com, and asynchronous work such as pipeline creation and import and export took unusually long.

   High latencyDatabase overloadOOMKilledHigh error rate

   Trigger

   The Consul agent in GitLab.com's GKE pods had memory demand spikes that did not fit in the pods' 500MB memory limit, and the agent was killed again and again.

   Root cause

   Capacity exhaustion

   Component

   Container memory limitService discoveryApplication database

   Contributing factor

   –

   Detection

   An engineer declared the incident in Slack at 15:13 UTC after the Sidekiq Apdex dropped; the second event was found when monitoring detected an elevated error rate at 01:21 UTC on 2022-04-26.

   Remediation

   • planned at 16:13 to raise the per-user connection limit for the gitlab database user and the pgbouncer backend pools for the main database; changes were applied at 17:26 and confirmed at 17:47
   • raised the pod memory limits from 500MB to 1GB so the Consul agents survive memory spikes

   Action items

   • Monitor the Consul agents on GKE pods to see whether the 1GB memory limit keeps them healthy
   • Investigate the Consul memory demand spikes and what can be done beyond raising the hard memory limit

   Lessons

   When the local Consul agent that Rails uses for database service discovery keeps dying, Rails does not fail; it sends every query to the last known primary. What engineers saw was database saturation and slow background jobs, which pointed the investigation first at a recent pgbouncer pool change. The memory limit of the Consul agent in every pod therefore decided the load on the primary database.

   View case
4. IL-0064 CPU-heavy pods packed onto one Google Cloud node drove it to kernel panics, and the crash moved from node to node until the site was down

   Moonlight2019

   Symptoms

   On Friday, January 18, Moonlight's API began returning occasional errors that looked like connection problems with its Redis database. The API checks Redis on every authenticated request to validate the session. At the same time the Kubernetes monitoring reported some nodes and pods as unresponsive.

   High error rateIntermittent connection failuresNode NotReadyService outageSustained high node CPU

   Trigger

   The Kubernetes scheduler put several CPU-heavy pods on the same node, including all three replicas of the website and the server-side rendering pods.

   Root cause

   Capacity exhaustion

   Component

   Pod scheduling and placementLinux kernelApplication database

   Contributing factor

   Single point of failureUnverified assumptionAutomation amplification

   Detection

   API errors that looked like Redis connectivity problems, and Kubernetes monitoring that showed nodes and pods as unresponsive. Google Cloud Support later found the link between sustained 100% CPU and kernel panics.

   Remediation

   • added anti-affinity rules to all major deployments so their pods spread across nodes

   Action items

   • Keep working with Google Cloud support to find and fix the cause of the node kernel panics

   Lessons

   Three replicas give no fault tolerance if the scheduler places them all on one node; anti-affinity rules make the spread explicit. A node failure that comes from the workload itself moves with the workload when the scheduler reschedules it.

   View case

By root cause1