Cases2 cases

1 to 2 of 2

1. IL-0006 VPC subnets ran out of IP addresses because the AWS VPC CNI kept IPs on full nodes, and WARM_IP_TARGET changes then blocked pod starts after every pod deletion

   Neon2025

   Symptoms

   On 16 May 2025, in Neon's Kubernetes cluster in AWS us-east-1, new compute pods were scheduled but could not start and failed with IP allocation errors. Each Neon compute is a Postgres database running in a lightweight virtual machine in its own pod, so without new pods, idle customer databases could not be woken up.

   IP address exhaustionPods Pending

   Trigger

   On 16 May the Neon control plane's periodic job that terminates idle computes started failing. Compute creations continued, and the number of active computes rose from about 5k to about 8.1k within minutes. On 19 May, a follow-up change that set WARM_IP_TARGET back to 1 started the second round of failures.

   Root cause

   Capacity exhaustion

   Component

   AWS VPC CNIVPC subnet or pod address rangeCluster autoscaler

   Contributing factor

   Unreviewed defaultsNo capacity planningUnverified assumptionHarmful manual actionIneffective rollbackRetry storm

   Detection

   As cluster-autoscaler added nodes, the team saw IP allocation errors on new pods that were scheduled but could not start. The rate of successful pod starts and VPC subnet metrics were then used to follow the problem.

   Remediation

   • Set WARM_IP_TARGET=1 to release IPs held by nodes without free CPU or memory
   • Fixed the control plane's periodic job so idle computes were terminated again
   • Restarted the aws-node DaemonSet several times, each with a temporary improvement
   • Set WARM_IP_TARGET=0, MINIMUM_IP_TARGET=0 and WARM_ENI_TARGET=0, which let nodes allocate enough IPs and stabilised the cluster
   • On 19 May, set WARM_IP_TARGET back to 0 after setting it to 1 failed again
   • Enlarged the pool of pre-created warm compute pods to absorb failed pod starts

   Action items

   • Open a pull request to AWS CNI to improve how ipamd releases IPs in this situation
   • Follow up with AWS Support about the roughly 100 subnet IPs that were never allocated, for reasons Neon could not explain
   • Change the architecture to support horizontal scaling

   Lessons

   With default settings AWS CNI can keep many IPs on nodes that cannot use them, so the share of subnet IPs assigned to pods does not tell how close the subnet is to running out. WARM_IP_TARGET and WARM_ENI_TARGET follow different logic, a warm IP target of zero switches to the ENI logic, and IPs in cooldown count toward the target, which behaves badly under high pod churn. Changing these settings during an incident without knowing that logic prolonged the outage, and reverting a setting did not bring back the earlier healthy state.

   View case
2. IL-0007 The AWS VPC CNI could not assign IP addresses to pods as an EKS cluster ran out of IPv4 space

   Adevinta2024

   Symptoms

   One evening the platform team that runs SCHIP, Adevinta's internal runtime platform on Kubernetes, was paged because some DaemonSets were failing. Checking the pod status showed this error from the network plugin: name="aws-cni" failed (add): add cmd: failed to assign an IP address to container

   IP address exhaustionPods Pending

   Trigger

   Not stated for the first page. It came in June, during the migration from SCHIP's kube-aws-based clusters to EKS-based clusters; the write-up mentions spikes of pods, such as a job that goes rogue or failing jobs that keep their IPs, as ways a cluster can run out.

   Root cause

   Capacity exhaustion

   Component

   AWS VPC CNIVPC subnet or pod address rangeKarpenter

   Contributing factor

   Unreviewed defaultsNo capacity planning

   Detection

   A pager alert that some DaemonSets were failing. The on-call engineer checked the pod status and found the aws-cni error about failing to assign an IP address.

   Remediation

   • Rolled out VPC CNI custom networking with a secondary CIDR to the smaller clusters from late August
   • Paused the EKS migration in September while available IPs were very low
   • Rolled out custom networking to the rest of the fleet
   • Added the --reserved-enis parameter to the Karpenter deployment

   Action items

   • Use VPC CNI custom networking with a secondary CIDR across the whole fleet
   • Make Karpenter account for custom networking with the --reserved-enis parameter

   Lessons

   For a platform team, the VPC CNI is not ready to scale in production without time spent on capacity planning, and every option has its pros and cons. For large clusters started today, IPv6 is the cheaper and more future-proof option. Do not assume that what works in small clusters will keep working when they grow.

   View case

By root cause1