Cases7 cases

1 to 5 of 7

1. IL-0100 PostHog's feature flags pods were packed onto Kubernetes nodes that were too small for their CPU requests, and CPU saturation above 90% caused three outages in ten days through Redis overload, connection pool exhaustion and slow queries

   PostHog2025

   Symptoms

   On 21 October 2025 at 21:45 UTC a change to timeout handling was deployed to the feature flags service, and two minutes later automated monitoring reported higher error rates. The change was rolled back by 21:49, but error rates stayed high: about 38% of flag evaluation requests in the US datacenter returned errors. At 22:30 Redis metrics showed memory exhaustion on ElastiCache, at 22:35 Postgres connections spiked, and at 22:45 the team found a massive data transfer from Postgres into Redis. The main PostHog application was affected as well, because it shares the Redis instance with the flags service.

   Sustained high node CPUHigh error rateHigh latencyContainer crash loopDatabase overload

   Trigger

   On 21 October a deployment meant to reduce timeout errors (PR #39821); on 24 October the deployment of IP-based rate limiting (PR #40074) that saw all traffic as coming from the load balancer's IP; on 28 October an unrelated routine deployment that rolled the feature flag pods in the US region.

   Root cause

   Capacity exhaustion

   Component

   Node poolPod scheduling and placementIn-memory cacheApplication database

   Contributing factor

   No alert on limitRetry stormIneffective rollbackSingle point of failureNo staged rolloutUnrepresentative staging

   Detection

   On 21 October automated monitoring detected higher error rates two minutes after the deploy. On 24 October no alert existed for 429 errors, and the team learned of the incident from customer reports that began at 18:10 UTC, a 62-minute detection delay. On 28 October on-call received a high error count alert. On 29 October the incident was reported with higher error rates and latency. No alert existed for CPU pressure, so the CPU saturation behind all three incidents was not seen directly.

   Remediation

   • rolled back the timeout handling change within 2 minutes on 21 October, which did not stop the errors
   • throttled connections and Redis writes on 21 October
   • halted the rollout on 28 October, scaled the US flags pods to zero until Redis recovered, then scaled them back gradually
   • rolled back hardware changes on 30 October at 00:03 UTC, which removed most errors but not the latency
   • increased the pod resource requests and adjusted the Kubernetes fleet size so fewer pods ran on each node
   • added retry limits to Envoy between the load balancer and the service
   • moved database connection timeouts and other critical settings to runtime configuration and raised the timeout values
   • added per-node and per-pod CPU alerts at 80% sustained for 5 minutes that page on-call

   Action items

   • Form a strike team from the flags, ingestion and infrastructure teams to review the application and infrastructure for remaining bottlenecks
   • Investigate separating the flags Redis instance from the application Redis instance
   • Before re-enabling ArgoCD sync, align the flags service chart configuration with the values in ArgoCD and define the deployment and Redis strategy
   • Make the feature flags team hard code-owners for flags-related code
   • Build a dashboard of key flag metrics with runbook links and update the feature flag runbooks
   • Add missing alerts on existing service and infrastructure metrics
   • Make readiness checks validate dependencies that degrade under load, for example by pinging the database
   • Rate-limit cache population so it cannot overwhelm Redis
   • Monitor connection pools with automatic throttling near exhaustion and limit concurrent connections
   • Build a production-scale load testing framework
   • Build progressive rollout infrastructure to limit blast radius
   • Document Postgres-to-Redis data flows and write runbooks for data transfer storms

   Lessons

   Nodes that are small relative to pod requests let the scheduler pack many pods on each node, and the resulting CPU saturation showed up three different ways: excessive parallelism, connection pool exhaustion and slow queries. Treating each symptom separately let the problem return; right-sizing the pods and nodes fixed all three. CPU must be alerted on from the start. Unbounded Envoy retries and unbounded cache population amplified the overload, and a Redis instance shared with the main application spread a flags problem to the main application. A rollback did not end the incident, because the data transfer and resource exhaustion it had started kept running.

   View case
2. IL-0145 A power sag and chiller failure in one Australia East availability zone took down the AKS control plane's compute and its non-zone-redundant SQL Database operation queue, blocking AKS create, update and delete operations in Australia East and Australia Southeast

   Microsoft Azure2023

   Symptoms

   From about 10:30 UTC on 30 August 2023, customers had trouble accessing or using Azure, Microsoft 365 and Power Platform services in Australia East. The affected Azure services included Azure Kubernetes Service (AKS) along with storage, SQL Database, Cosmos DB, virtual machines and Azure Resource Manager.

   Control plane unresponsiveHigh error rateService outage

   Trigger

   At 08:41 UTC a lightning strike on electrical infrastructure about 18 miles away caused a utility voltage sag that shut down the cooling chillers of datacenters in one Australia East availability zone; 13 chillers failed to restart automatically and five could not be restarted, so two data halls overheated and their infrastructure was shut down.

   Root cause

   Cloud provider outage

   Component

   AKS control planeApplication database

   Contributing factor

   Single point of failureExcessive blast radius

   Detection

   Cosmos DB impact was detected by monitoring at 10:47 UTC, first automated communications went to Azure Service Health at 10:48 UTC, the public Azure Status page was updated at 11:30 UTC, and all subscriptions in Australia East were sent portal communications at 11:36 UTC.

   Remediation

   • shut down the remaining networking, compute and storage in the two affected data halls so the chilled water loop could cool down
   • restarted the five chillers manually at 12:12 UTC
   • restored power to all hardware by 15:10 UTC and brought infrastructure back in phases
   • restored AKS operations through the recovery of the SQL Database operation queue, with no other mitigation

   Action items

   • AKS: convert all operation queue SQL Database databases to be zone redundant (estimated September 2023)
   • AKS: replace all cross-region SQL Database queue usage with zone-redundant Service Bus queues (estimated September 2023)
   • Change the control timing logic of the Chiller Management System so chillers do not fail to restart after voltage fluctuations
   • Change the emergency procedure for manual restarts of simultaneous chiller failures from an adjacent sequence to a load-based sequence per data hall
   • Increase technician staffing at the datacenter as a temporary measure for manual chiller restarts
   • Storage: optimise the large-scale recovery process and update troubleshooting guides (estimated December 2023)
   • Azure Service Fabric: improve reliability of SQL Database tenant ring recovery (estimated December 2023)
   • SQL Database: review the trigger criteria of auto-failover groups (estimated October 2023)
   • SQL Database: upgrade internal tooling to enable mass migration of databases (estimated December 2023)
   • Cosmos DB: optimise Service Managed Failover for single-region-write accounts (estimated November 2023)
   • ARM: complete the migration of its storage layer to the zonally redundant architecture (estimated December 2023)
   • Incident management: harden readiness, process and playbook for power-down scenarios (estimated October 2023)

   Lessons

   A control plane spread across availability zones still fails with a zone when one of its dependencies, here the SQL Database operation queue, is not zone redundant. When a second region uses the same database, the failure crosses into that region as well. Workloads already running were not expected to be affected; what stopped was everything that needs the managed service's control plane, such as scaling and cluster changes.

   View case
3. IL-0060 Kubernetes 1.24 upgrade removed the master node label that Calico route reflectors selected on, dropping all pod routes and taking Reddit down for 314 minutes

   Reddit2023

   Symptoms

   About two minutes after an engineer started the Kubernetes 1.23 to 1.24 upgrade of the cluster running Reddit's legacy stack, just after 19:00 UTC, the site stopped. The CDN edge request graph, which is kept separate from the cluster, showed traffic by status collapsing. Users saw the error page, a homepage with no posts, or plain errors.

   Service outageHigh error rateDNS resolution failuresMonitoring outagePods stuck in ContainerCreatingControl plane lag

   Trigger

   An in-place upgrade of the legacy cluster from Kubernetes 1.23 to 1.24; in 1.24 the node-role.kubernetes.io/master label is removed even from running clusters.

   Root cause

   Breaking change in an upgrade

   Component

   CalicoKubernetes API serverAdmission webhooketcd

   Contributing factor

   Configuration not in codeUnrepresentative stagingUntested backupMonitoring blind spotSingle point of failure

   Detection

   The site broke about two minutes into the upgrade; an incident was opened immediately and responders were on the call within three minutes, working from CDN edge graphs because the cluster's own metrics were gone.

   Remediation

   • deleted the Open Policy Agent webhook configurations to stop API server timeouts
   • terminated all worker nodes of the cluster
   • restored the control plane from the pre-upgrade backup onto the first control plane node
   • switched off the cluster autoscaler until the control plane was stable
   • generated new TLS certificates so replacement control plane nodes could join etcd
   • brought traffic back in steps from 1% to 100%
   • restarted legacy services that had been stopped by hand

   Action items

   • Codify cluster configuration so every choice has a record, and document in detail what cannot be codified
   • Standardise components across clusters and replace bespoke configurations
   • Build tooling to manage the lifecycle of whole clusters so they can be recreated or replicated
   • Add pre-production clusters that can be tested with confidence
   • Improve the backup restore process and make cluster upgrades safe

   Lessons

   Configuration that exists only in a live cluster, edited by hand through a special tool, can be forgotten, as the route reflector setup was, and then break on an upgrade nobody connects it to. A Kubernetes upgrade cannot be reverted without a restore, so the restore procedure has to be kept current and practised. Consistent, codified clusters are what make upgrades testable; bespoke clusters keep producing outages.

   View case
4. IL-0002 CI builder pods could not get AWS IAM credentials because kubelet fell minutes behind its API rate limit

   Zalando2019

   Symptoms

   Builds on Zalando's in-house Continuous Delivery Platform (CDP), which runs CI/CD on Kubernetes, timed out and failed for almost an hour on 11 June 2019. The Kubernetes builder pods could not get AWS IAM credentials.

   High error rateCredentials unavailableControl plane lag

   Trigger

   An unlucky rescaling of the CDP Kubernetes cluster left only one node available for builder pods. Builder pods were created and deleted on that node so quickly that kubelet fell behind.

   Root cause

   Capacity exhaustion

   Component

   kubeletCredential broker for podsKubernetes API serverCI system

   Contributing factor

   Unreviewed defaultsSingle point of failure

   Remediation

   • Scaled the CDP cluster up by hand so builder pods spread over more than one node

   Action items

   • Raise the kubelet QPS limit from the default 5 to 50 in the global cluster configuration

   View case
5. IL-0064 CPU-heavy pods packed onto one Google Cloud node drove it to kernel panics, and the crash moved from node to node until the site was down

   Moonlight2019

   Symptoms

   On Friday, January 18, Moonlight's API began returning occasional errors that looked like connection problems with its Redis database. The API checks Redis on every authenticated request to validate the session. At the same time the Kubernetes monitoring reported some nodes and pods as unresponsive.

   High error rateIntermittent connection failuresNode NotReadyService outageSustained high node CPU

   Trigger

   The Kubernetes scheduler put several CPU-heavy pods on the same node, including all three replicas of the website and the server-side rendering pods.

   Root cause

   Capacity exhaustion

   Component

   Pod scheduling and placementLinux kernelApplication database

   Contributing factor

   Single point of failureUnverified assumptionAutomation amplification

   Detection

   API errors that looked like Redis connectivity problems, and Kubernetes monitoring that showed nodes and pods as unresponsive. Google Cloud Support later found the link between sustained 100% CPU and kernel panics.

   Remediation

   • added anti-affinity rules to all major deployments so their pods spread across nodes

   Action items

   • Keep working with Google Cloud support to find and fix the cause of the node kernel panics

   Lessons

   Three replicas give no fault tolerance if the scheduler places them all on one node; anti-affinity rules make the spread explicit. A node failure that comes from the workload itself moves with the workload when the scheduler reschedules it.

   View case

By root cause4