Cases15 cases

6 to 10 of 15

1. IL-0203 A routine Kubernetes cluster system update made the AWS Load Balancer Controller fail, so new pods were never registered with the ALB and Honeycomb's EU1 ingest and UI went down once the last old pods were replaced

   Honeycomb2024

   Symptoms

   Event ingestion and the Honeycomb UI in EU1 became unavailable at 22:00:10 UTC on April 9, 2024, and the status page reported that the EU1 instance was down. Both the ingestion service and the service behind the web UI stopped at roughly the same moment.

   Service outageStale endpoint routing

   Trigger

   A routine system update to the Kubernetes cluster, rolled out earlier on April 9, followed by a regular deployment that replaced pods one at a time.

   Root cause

   Breaking change in an upgrade

   Component

   Ingress controllerCloud load balancer

   Contributing factor

   Monitoring blind spotUnrepresentative stagingChange with a delayed effect

   Detection

   The first status post, saying the EU1 instance was down, went up at 15:08 PDT (22:08 UTC), about 8 minutes after the outage began. There was no alerting on the AWS Load Balancer Controller.

   Remediation

   • Restarted the AWS Load Balancer Controller
   • Rolled back the Kubernetes cluster system update

   Action items

   • Find the exact cause of the failure so the system update can be deployed safely
   • Add monitoring and alerting on the AWS Load Balancer Controller so on-call engineers learn of a failure quickly and can pause deployments

   Lessons

   A rolling deployment can look healthy while the component that wires new pods into the load balancer is broken; the failure only shows when the last old pod goes away. Honeycomb now treats the AWS Load Balancer Controller as a critical component that needs its own alerting, so deployments can be paused before they remove the last pods that still receive traffic. Extensive testing in development and staging did not reveal the bad interaction.

   View case
2. IL-0178 On EKS, HPA scale-in returned 502 errors because containers stopped before their pod IPs left the Service endpoints, and after blue/green switches conntrack kept sending established connections to deleted pods behind an instance-mode ALB

   Lotte E-commerce2022

   Symptoms

   LOTTE ON, Lotte E-commerce's online shopping mall of about 40 microservices on Amazon EKS, returned errors for a period of time whenever the Horizontal Pod Autoscaler (HPA) scaled pods in after load dropped. Requests reached containers that had already been deleted and failed with 502 errors.

   High error rateIntermittent timeoutsStale endpoint routing

   Trigger

   HPA scale-in deleting pods, and the deletion of Blue pods after a blue/green switch of the Service label selector.

   Root cause

   DNS or network fault

   Component

   Horizontal pod autoscalerPod terminationkube-proxyconntrack tableCloud load balancerIngress controller

   Contributing factor

   Unreviewed defaults

   Remediation

   • delayed container shutdown on pod deletion (a wait in the SIGTERM handler or a preStop sleep, capped by terminationGracePeriodSeconds) so containers stop only after the pod has left the Service endpoints
   • switched some workloads' Ingress-created ALBs from instance mode to IP mode so traffic goes straight to pod IPs without iptables and conntrack

   Action items

   • Move all workloads to ALB IP mode gradually

   Lessons

   Removing a pod from Service endpoints and stopping its containers happen at the same time in Kubernetes, so a pod can stop while traffic is still routed to it unless shutdown is delayed with a preStop hook or in the application. With an instance-mode ALB, traffic passes through node iptables and conntrack, and established connections can keep going to a pod IP after its iptables rules are gone. IP mode avoids that path, within the limit of 1000 targets per target group.

   View case
3. IL-0177 WebSocket connections to LINE's messaging-hub on Kubernetes dropped all at once whenever another service's change reloaded a shared HAProxy L7 load balancer, and the reconnect wave overloaded a token API and filled nf_conntrack on Nginx

   LINE+2022

   Symptoms

   The graph of WebSocket connections to messaging-hub, the messaging platform used by the Japanese food delivery service Demaecan, showed sudden deep drops even outside peak traffic. The drops kept coming back at irregular intervals. Messages still reached clients, because messaging-hub switches to Firebase Cloud Messaging when a WebSocket is gone.

   Connection resetsDatabase overloadIntermittent connection failuresHigh latency

   Trigger

   Another service that shared the same L7 load balancer deployed its own load balancer configuration in the Verda dashboard, which reloaded HAProxy; 30 minutes later, at the hard-stop-after limit, the old HAProxy process exited and closed every WebSocket connection it still held.

   Root cause

   Configuration change

   Component

   HAProxyCloud load balancerconntrack tableIngress controller

   Contributing factor

   Change with a delayed effectExcessive blast radiusRetry stormUnverified assumption

   Detection

   The developer noticed deep, sudden drops in the WebSocket connection graph that were not tied to peak traffic and kept recurring irregularly. The Nginx packet drops were found through network monitoring.

   Remediation

   • separated the Merchant system's token issuance API into its own deployment so reconnect traffic did not delay other Merchant APIs
   • scaled out Nginx with pod anti-affinity and a label selector so each pod ran on a different node, which stopped the nf_conntrack packet drops
   • raised Ingress Nginx proxy-read-timeout and proxy-send-timeout and the load balancer timeout to 3600s, which did not stop the drops
   • moved messaging-hub from the shared L7 load balancer to an L4 load balancer, which ended the WebSocket drops

   Lessons

   A reload of a shared load balancer by a different team can cut long-lived connections, and with hard-stop-after the cut comes 30 minutes later, far from the change that caused it. The author's lesson is not to narrow the scope of the search too early: trusting that the infrastructure was fine kept the investigation inside the team's own systems for days. A reconnect wave from many WebSocket clients can overload the systems that issue connection tokens and fill nf_conntrack on proxy nodes. Scaling Nginx out only helps for conntrack if the pods land on different nodes, and anti-affinity leaves extra replicas Pending once they outnumber the nodes. That messaging-hub problems can still load the connected systems remains an open problem.

   View case
4. IL-0208 A GitLab chart bump that renamed Kubernetes Service and Deployment ports made the GCP load balancer reconfigure, and GitLab.com slowed down and returned intermittent 50x errors

   GitLab2022

   Symptoms

   At 07:53 UTC on 2022-03-31 the rate of 50x errors on GitLab.com went up, and at 07:54 PagerDuty paged the engineer on call (EOC) about the rising error rate. Users saw slow pages and intermittent 50x error pages. The incident lists the Web, API, Git and Pages services as affected.

   High error rateHigh latencyIntermittent timeouts

   Trigger

   A k8s-workloads/gitlab-com pipeline deployed merge request !1643, a GitLab chart bump that changed the port names of Kubernetes Services and Deployments (related to the Prometheus service and pod monitors), starting with the canary environment gprd-cny at 07:49 UTC.

   Root cause

   Configuration change

   Component

   HelmCloud load balancerHAProxy

   Contributing factor

   Automation amplification

   Detection

   A PagerDuty alert on the rising error rate paged the EOC at 07:54 UTC, one minute after the 50x errors went up. The engineer deploying the change noticed the errors and linked them to it.

   Remediation

   • drained the canary environment and re-enabled it after twenty minutes
   • cancelled the deployment jobs for clusters c and d before they started
   • drained gprd-us-east1-d in HAProxy and re-enabled it five minutes later
   • raised the minimum replica count above 100 (merge request !1650)
   • drained gprd-us-east1-c in HAProxy, deployed the change to it, and re-enabled it
   • reverted the minimum replica increase (merge request !1652)

   Action items

   • Implement graceful draining of a whole regional cluster
   • Create a Chatops command that puts PagerDuty into maintenance mode

   Lessons

   Renaming ports on Kubernetes Services and Deployments behind a GCP load balancer made the load balancer reconfigure, and requests were slow or timed out until the new configuration had fully applied, which took minutes. GitLab notes that alerting worked well. The follow-up work is a way to drain a whole regional cluster gracefully and a Chatops command to put PagerDuty into maintenance mode.

   View case
5. IL-0106 A malformed Traefik IngressRoute triggered a Traefik v2 bug once a node rollover restarted every Traefik pod, and all Kubernetes services returned 404

   DFDS2021

   Symptoms

   At 08:00 UTC on 2021-09-06 every service in DFDS's Kubernetes cluster answered with 404. Investigation started five minutes later.

   Service outageHigh error rateProbe failures

   Trigger

   The automated Kubernetes node rollover on 2021-09-06 restarted all the Traefik v2 pods, five days after a malformed IngressRoute manifest had been applied.

   Root cause

   Software defect

   Component

   Ingress controllerCloud load balancer

   Contributing factor

   Change with a delayed effectNo configuration testsExcessive blast radius

   Detection

   All services returned 404 from 08:00 UTC and root cause investigation started at 08:05. Time to detection was 5 minutes.

   Remediation

   • changed the ALB health check path, which made the targets healthy but did not stop the 404s
   • rolled back by hand to Traefik v1 as the main ingress controller
   • deleted the malformed IngressRoute by hand and confirmed the Traefik v2 bug
   • applied the changes upstream

   Action items

   • Upgrade Traefik to v2.5, where the bug is fixed, and verify that it removes the bug
   • Change the Traefik v2 health check path to something more robust
   • Set up an external liveness probe on the ingress controller
   • Consider workload segmentation to limit the blast zone
   • Look into monitoring the Traefik v2 API for rapid changes
   • Look into smoke testing during and after node rollover

   Lessons

   A malformed IngressRoute did nothing visible for five days and then took down all ingress when every Traefik v2 pod had restarted during a node rollover. Because Traefik v2 failed gracefully, the first signals pointed at the ALB health checks instead of at Traefik. On incident handling, the team concluded that appointing an incident manager could have helped, that the war room meeting should be recorded and a log book kept, that people not involved should only make suggestions in writing, and that a short first round of sharing thoughts and gut feelings is useful.

   View case

By root cause6